Safety Regulations for Palletizing Robots During Operation

All responses

• Best response

  Accepted

  Palletizing Robot Safety Regulations During Operation; What safety issues should be noted when using a palletizer:
  
  

  1. During the automatic operation of the palletizing robot, never enter the safety fence or extend any part of your body into it. At the same time, please confirm that there are no personnel or obstacles left inside the safety fence before starting the robot.

  2. During automatic operation, the palletizing robot may appear to have stopped when it is waiting for a timer delay or external signal input. However, do not approach the robot at this time, as it will resume operation immediately when the timer expires or the external signal is received.

  3. It is extremely dangerous if, during the automatic operation of the palletizing robot, the grip on the workpiece is insufficient, as the workpiece may be thrown off during robot movement. Please be sure to confirm that the workpiece is firmly gripped. When the workpiece is grasped by a pneumatic gripper, electromagnetic mechanism, or similar method, please adopt a fail-safe system to ensure that the workpiece is not ejected if the driving force of the mechanism is suddenly cut off. Even if the possibility of the workpiece falling out during an error is minimal, please install protective barriers such as mesh covers. Do not enter the work area during operation. At the same time, please confirm the safety通道 (Note: This word was in Chinese in the original; likely means "passage" or "exit") to allow operators to evacuate in an emergency.

  4. If a fault causes the robot to stop during automatic operation, please check the displayed fault message and restore and restart the robot according to the correct fault recovery procedure.

  5. After the fault recovery procedure and before restarting the robot, please confirm that the safety working conditions are met and that there are no personnel, fixtures, peripheral devices, or obstacles left inside the safety protection devices or around the robot.